![]() NOTE: Do not format the drive, rather, continue to Stage One. Open the formatting window for the drive to confirm that the capacity cannot be switched back to its original state.Check the used and available space on your USB drive.Use Diskpart Command To Recover Partition Capacity All you need to do, to restore pen drive capacity back to the original, is carefully follow each step mentioned below: Before starting to reclaim a pen drive data storage capacity, perform the following steps: ![]() NOTE: This command line method is applicable on all types of external storage media’s including flash drives, SD cards, etc., of NT, FAT32, & FAT16 File Systems, respectively. Two major steps that are involved during the execution of diskpart command, are: However, this mostly doesn’t help in solving the problem to any extent and leaves the user amused as to how to restore a pen drive’s capacity back in original state? Implementing The Diskpart Command Diskpart is a command line using which, one can successfully recover the unallocated space on their pen drive to regain its original storage capacity. The first attempt to overcome this condition by most users is to scan and format the drive to free it from any possible infections. Select a disk that you want to format by type select disk 0 (e.g. Type: select disk n (where n is the number of your USB drive). Now, you will see a list of disk which shows all disks on your computer. if the USB device storage capacity is 4 GB then, only 500 MB of it will be shown as available. In the first place, connect your USB drive to your computer and make sure it can be detected. This, however, happens usually when a malware has hit the device ending up hiding its original storage capacity, i.e. Modified: T16:22:49+00:00| Tips | 5 Minutes ReadingĪny user would be highly disappointed knowing that they are unable to make use of the complete storage capacity of their USB drive.
0 Comments
Leave a Reply. |